Feedback on: Introduction to Visual Basic Scripting (VBScript), August 03, 2001 at 09:16:42:

You are here: irt.org | About | Feedback | 3046 [ previous next ]

Feedback on:
Introduction to Visual Basic Scripting (VBScript)

Sent by
gerri albee on August 03, 2001 at 09:16:42:

Comments:
i haven't looked too much at your page, but i like it so far....just wanted to tell you that you should probably include "End If" in your syntax list....also, is there a VBScript equivalent to the C++ "else if" statement? it wasn't in the page

Other feedback on 'Introduction to Visual Basic Scripting (VBScript)' - show all

Introduction to Visual Basic Scripting (VBScript) - Ashish Gupta June 12, 2008 at 08:29:52
Introduction to Visual Basic Scripting (VBScript) - Dawn July 13, 2007 at 04:26:51
Introduction to Visual Basic Scripting (VBScript) - Vance Burke December 09, 2002 at 10:09:14
Introduction to Visual Basic Scripting (VBScript) - Amiya Basak November 22, 2002 at 03:26:34
Introduction to Visual Basic Scripting (VBScript) - Bob Moran May 13, 2002 at 11:45:27
Introduction to Visual Basic Scripting (VBScript) - alex October 03, 2001 at 04:05:37
Introduction to Visual Basic Scripting (VBScript) - gerri albee August 03, 2001 at 09:16:42
Introduction to Visual Basic Scripting (VBScript) - lissa November 17, 2000 at 06:11:39
Introduction to Visual Basic Scripting (VBScript) - Mike Sabatier October 02, 2000 at 05:25:49
Introduction to Visual Basic Scripting (VBScript) - raghu June 12, 2000 at 06:27:31
Introduction to Visual Basic Scripting (VBScript) - Pat Magnan September 15, 1998 at 22:29:22