You are here: irt.org | RFCs | RFC2438 [ previous next ]
Network Working Group M. O'Dell
Request for Comments: 2438 UUNET Technologies
BCP: 27 H. Alvestrand
Category: Best Current Practice Maxware
B. Wijnen
IBM T. J. Watson Research
S. Bradner
Harvard University
October 1998
Advancement of MIB specifications on the IETF Standards Track
Status of this Memo
This document specifies an Internet Best Current Practices for the
Internet Community, and requests discussion and suggestions for
improvements. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (1998). All Rights Reserved.
2. Abstract
The Internet Standards Process [1] requires that all IETF Standards
Track specifications must have "multiple, independent, and
interoperable implementations" before they can be advanced beyond
Proposed Standard status. This document specifies the process which
the IESG will use to determine if a MIB specification document meets
these requirements. It also discusses the rationale for this
process.
3. The Nature of the Problem
The Internet Standards Process [1] requires that for an IETF
specification to advance beyond the Proposed Standard level, at least
two genetically unrelated implementations must be shown to
interoperate correctly with all features and options. There are two
distinct reasons for this requirement.
The first reason is to verify that the text of the specification is
adequately clear and accurate. This is demonstrated by showing that
multiple implementation efforts have used the specification to
achieved interoperable implementations.
O'Dell, et. al. Best Current Practice [Page 1]
RFC 2438 Advancement of MIB specifications October 1998 The second reason is to discourage excessive options and "feature creep". This is accomplished by requiring interoperable implementation of all features, including options. If an option is not included in at least two different interoperable implementations, it is safe to assume that it has not been deemed useful and must be removed before the specification can advance. In the case of a protocol specification which specifies the "bits on the wire" exchanged by executing state machines, the notion of "interoperability" is reasonably intuitive - the implementations must successfully "talk to each other", exchanging "bits on the wire", while exercising all features and options. In the case of an SNMP Management Information Base (MIB) specification, exactly what constitutes "interoperation" is less obvious. This document specifies how the IESG has decided to judge "MIB specification interoperability" in the context of the IETF Standards Process. There are a number of plausible interpretations of MIB specification interoperability, many of which have merit but which have very different costs and difficulties in realization. The aim is to ensure that the dual goals of specification clarity and feature evaluation have been met using an interpretation of the concept of MIB specification interoperability that strikes a balance between testing complexity and practicality. 4. On The Nature of MIB specifications Compared to "state machine" protocols which focus on procedural specifications, a MIB specification is much more data oriented. To over-generalize, in a typical MIB specification the collection of data type and instance specifications outnumbers inter-object procedural or causal semantics by a significant amount. A central issue is that a MIB specification does not stand alone; it forms the access interface to the instrumentation underneath it. Without the instrumentation, a MIB has form but no values. Coupled with the large number of objects even in a simple MIB specification, a MIB specification tends to have more of the look and feel of an API or a dictionary than a state machine protocol. It is important to distinguish between assessing the interoperability of applications which may use or interact with MIBs, and the MIBs themselves. It is fairly obvious that "black-box testing" can be O'Dell, et. al. Best Current Practice [Page 2]
RFC 2438 Advancement of MIB specifications October 1998 applied to such applications and that the approach enjoys a certain maturity in the software engineering arts. A MIB specification, on the other hand is not readily amenable to black box test plans. 5. Discussion and Recommended Process In order to meet their obligations under the IETF Standards Process, the Operations and Management Area Directors and the IESG must be convinced that each MIB specification advanced to Draft Standard or Internet Standard status is clearly written, that there are the required multiple interoperable implementations, and that all options have been implemented. There are multiple ways to achieve this goal. Appendix A lists some testing approaches that could be used when attempting to document multiple implementations. The Full Coverage or Stimulus-Response approaches are very through, and would increase confidence that the requirement has been met, if applied. However, experience in real-world software engineering makes it clear that such confidence comes at an extremely high price; even with the most exhaustive testing, it is often not clear what precisely has been demonstrated by such testing. We believe that both of those standards of evidence are materially beyond what can be reasonably accomplished in an operational sense, and achieving the requisite semantic specifications are even more unlikely. Therefore, the Operations and Management Area and the IESG have adopted a more pragmatic approach to determining the suitability of a MIB specification for advancement on the standards track beyond Proposed Standard status. Each MIB specification suggested for advancement must have one or more advocates who can make a convincing argument that the MIB specification meets the multiple implementation and feature support requirements of the IETF Standards Process. The specific way to make the argument is left to the advocate, but will normally include reports that basic object comparison testing has been done. Thus any recommendation for the advancement of a MIB specification must be accompanied by an implementation report, as is the case with all requests for the advancement of IETF specifications. The implementation report must include the reasons why the IESG should believe that there are multiple implementations of the MIB specification in question and that the all of the MIB objects in the specification to be advanced are supported in more than one implementation. But note that the prime concern of the IESG will be that the underlying reasons for the interoperable implementations are met, i.e., that the text of the specification is clear and unambiguous, and that features of the specification which have not garnered support have been removed. O'Dell, et. al. Best Current Practice [Page 3]
RFC 2438 Advancement of MIB specifications October 1998 The implementation report will be placed on the IETF web page along with the other pre-advancement implementation reports and will be specifically referred to in the IETF Last-Call. As with all such implementation reports, the determination of adequacy is made by the Area Director(s) of the relevant IETF Area. This determination of adequacy can be challenged during the Last-Call period. 6. Security Considerations Some may view this policy as possibly leading to a reduction in the level of confidence people can have in MIB specifications but the O&M Area Directors and the IESG feel that it will adequately ensure a reasonable evaluation of the level of clarity of MIB specifications and to ensure that unused options can be identified and removed before the advancement of a specification. Good, clearly written MIB specifications can be of great assistance in the management of the Internet and other networks and thus assist in the reduction of some types of security threats. 8. References [RFC2026] Bradner, S., "The Internet Standards Process -- Revision 3", BCP 9, RFC 2026, October 1996. O'Dell, et. al. Best Current Practice [Page 4]
RFC 2438 Advancement of MIB specifications October 1998 9. Authors' Addresses Michael D. O'Dell UUNET Technologies, Inc. 3060 Williams Drive Fairfax, VA 22031 Phone: +1-703-206-5890 EMail: mo@uu.net Harald T. Alvestrand Maxware Pirsenteret N-7005 Trondheim, Norway Phone: +47-73-54-57-94 EMail: Harald.Alvestrand@maxware.no Bert Wijnen IBM T. J. Watson Research Schagen 33 3461 GL Linschoten Netherlands Phone: +31-348-432-794 EMail: wijnen@vnet.ibm.com Scott Bradner Harvard University 1350 Mass. Ave. Cambridge MA 02138 Phone: +1-617-495-3864 EMail: sob@harvard.edu O'Dell, et. al. Best Current Practice [Page 5]
RFC 2438 Advancement of MIB specifications October 1998 Appendix A A. Some Testing Alternatives The IESG debated a number of interoperability and testing models in formulating this specification. The following list is not an exhaustive enumeration of the alternatives, but it does capture the major plausible models which were examined in the course of the discussion. A.1 Basic Object Comparison Assume the requisite two genetically unrelated implementations of the MIB in an SNMP agent and an SNMP management station which can do a "MIB Dump" (extract the complete set of MIB object types and values from the agent implementation). Extract a MIB Dump from each implementation and compare the two dumps to verify that both provide the complete set of mandatory and optional objects and that the individual objects are of the correct types. A.2 Stimulus/Response Testing Proceed as in A.1, but in addition, comprehensively exercise the two (network) elements containing the agent implementations to verify that all the MIB objects reflect plausible values in operational conditions. An even stricter interpretation would require that the MIB objects in the two network elements track identically given the identical stimulus. While this would test "read-only" or "monitoring" information obtained from the underlying instrumentation, it is important to observe that such instrumentation is actually an *application* which uses the MIB and is not part of the MIB itself. A.3 Full Coverage Testing This model extends the notion of Stimulus/Response Testing to its logical extreme. The MIB is viewed as an API and the software engineering notion of full coverage testing is applied to a MIB. This involves exercising all paths through the causal semantics and verifying that all objects change state correctly in all cases. Again, note that much more than the MIB definition is being exercised and evaluated. O'Dell, et. al. Best Current Practice [Page 6]
RFC 2438 Advancement of MIB specifications October 1998 Full Copyright Statement Copyright (C) The Internet Society (1998). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. O'Dell, et. al. Best Current Practice [Page 7]