You are here: irt.org | RFCs | RFC2537 [ previous next ]
Network Working Group D. Eastlake Request for Comments: 2537 IBM Category: Standards Track March 1999 RSA/MD5 KEYs and SIGs in the Domain Name System (DNS) Status of this Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Copyright Notice Copyright (C) The Internet Society (1999). All Rights Reserved. Abstract A standard method for storing RSA keys and and RSA/MD5 based signatures in the Domain Name System is described which utilizes DNS KEY and SIG resource records. Table of Contents Abstract...................................................1 1. Introduction............................................1 2. RSA Public KEY Resource Records.........................2 3. RSA/MD5 SIG Resource Records............................2 4. Performance Considerations..............................3 5. Security Considerations.................................4 References.................................................4 Author's Address...........................................5 Full Copyright Statement...................................6 1. Introduction The Domain Name System (DNS) is the global hierarchical replicated distributed database system for Internet addressing, mail proxy, and other information. The DNS has been extended to include digital signatures and cryptographic keys as described in [RFC 2535]. Thus the DNS can now be secured and used for secure key distribution. Eastlake Standards Track [Page 1]
RFC 2537 RSA/MD5 KEYs and SIGs in the DNS March 1999 This document describes how to store RSA keys and and RSA/MD5 based signatures in the DNS. Familiarity with the RSA algorithm is assumed [Schneier]. Implementation of the RSA algorithm in DNS is recommended. The key words "MUST", "REQUIRED", "SHOULD", "RECOMMENDED", and "MAY" in this document are to be interpreted as described in RFC 2119. 2. RSA Public KEY Resource Records RSA public keys are stored in the DNS as KEY RRs using algorithm number 1 [RFC 2535]. The structure of the algorithm specific portion of the RDATA part of such RRs is as shown below. Field Size ----- ---- exponent length 1 or 3 octets (see text) exponent as specified by length field modulus remaining space For interoperability, the exponent and modulus are each currently limited to 4096 bits in length. The public key exponent is a variable length unsigned integer. Its length in octets is represented as one octet if it is in the range of 1 to 255 and by a zero octet followed by a two octet unsigned length if it is longer than 255 bytes. The public key modulus field is a multiprecision unsigned integer. The length of the modulus can be determined from the RDLENGTH and the preceding RDATA fields including the exponent. Leading zero octets are prohibited in the exponent and modulus. 3. RSA/MD5 SIG Resource Records The signature portion of the SIG RR RDATA area, when using the RSA/MD5 algorithm, is calculated as shown below. The data signed is determined as specified in [RFC 2535]. See [RFC 2535] for fields in the SIG RR RDATA which precede the signature itself. hash = MD5 ( data ) signature = ( 00 | 01 | FF* | 00 | prefix | hash ) ** e (mod n) Eastlake Standards Track [Page 2]
RFC 2537 RSA/MD5 KEYs and SIGs in the DNS March 1999 where MD5 is the message digest algorithm documented in [RFC 1321], "|" is concatenation, "e" is the private key exponent of the signer, and "n" is the modulus of the signer's public key. 01, FF, and 00 are fixed octets of the corresponding hexadecimal value. "prefix" is the ASN.1 BER MD5 algorithm designator prefix specified in [RFC 2437], that is, hex 3020300c06082a864886f70d020505000410 [NETSEC]. This prefix is included to make it easier to use RSAREF (or similar packages such as EuroRef). The FF octet MUST be repeated the maximum number of times such that the value of the quantity being exponentiated is the same length in octets as the value of n. (The above specifications are identical to the corresponding part of Public Key Cryptographic Standard #1 [RFC 2437].) The size of n, including most and least significant bits (which will be 1) MUST be not less than 512 bits and not more than 4096 bits. n and e SHOULD be chosen such that the public exponent is small. Leading zero bytes are permitted in the RSA/MD5 algorithm signature. A public exponent of 3 minimizes the effort needed to verify a signature. Use of 3 as the public exponent is weak for confidentiality uses since, if the same data can be collected encrypted under three different keys with an exponent of 3 then, using the Chinese Remainder Theorem [NETSEC], the original plain text can be easily recovered. This weakness is not significant for DNS security because we seek only authentication, not confidentiality. 4. Performance Considerations General signature generation speeds are roughly the same for RSA and DSA [RFC 2536]. With sufficient pre-computation, signature generation with DSA is faster than RSA. Key generation is also faster for DSA. However, signature verification is an order of magnitude slower with DSA when the RSA public exponent is chosen to be small as is recommended for KEY RRs used in domain name system (DNS) data authentication. Current DNS implementations are optimized for small transfers, typically less than 512 bytes including overhead. While larger transfers will perform correctly and work is underway to make larger Eastlake Standards Track [Page 3]
RFC 2537 RSA/MD5 KEYs and SIGs in the DNS March 1999 transfers more efficient, it is still advisable at this time to make reasonable efforts to minimize the size of KEY RR sets stored within the DNS consistent with adequate security. Keep in mind that in a secure zone, at least one authenticating SIG RR will also be returned. 5. Security Considerations Many of the general security consideration in [RFC 2535] apply. Keys retrieved from the DNS should not be trusted unless (1) they have been securely obtained from a secure resolver or independently verified by the user and (2) this secure resolver and secure obtainment or independent verification conform to security policies acceptable to the user. As with all cryptographic algorithms, evaluating the necessary strength of the key is essential and dependent on local policy. For interoperability, the RSA key size is limited to 4096 bits. For particularly critical applications, implementors are encouraged to consider the range of available algorithms and key sizes. References [NETSEC] Kaufman, C., Perlman, R. and M. Speciner, "Network Security: PRIVATE Communications in a PUBLIC World", Series in Computer Networking and Distributed Communications, 1995. [RFC 2437] Kaliski, B. and J. Staddon, "PKCS #1: RSA Cryptography Specifications Version 2.0", RFC 2437, October 1998. [RFC 1034] Mockapetris, P., "Domain Names - Concepts and Facilities", STD 13, RFC 1034, November 1987. [RFC 1035] Mockapetris, P., "Domain Names - Implementation and Specification", STD 13, RFC 1035, November 1987. [RFC 1321] Rivest, R., "The MD5 Message-Digest Algorithm", RFC 1321 April 1992. [RFC 2535] Eastlake, D., "Domain Name System Security Extensions", RFC 2535, March 1999. [RFC 2536] EastLake, D., "DSA KEYs and SIGs in the Domain Name System (DNS)", RFC 2536, March 1999. Eastlake Standards Track [Page 4]
RFC 2537 RSA/MD5 KEYs and SIGs in the DNS March 1999 [Schneier] Bruce Schneier, "Applied Cryptography Second Edition: protocols, algorithms, and source code in C", 1996, John Wiley and Sons, ISBN 0-471-11709-9. Author's Address Donald E. Eastlake 3rd IBM 65 Shindegan Hill Road, RR #1 Carmel, NY 10512 Phone: +1-914-276-2668(h) +1-914-784-7913(w) Fax: +1-914-784-3833(w) EMail: dee3@us.ibm.com Eastlake Standards Track [Page 5]
RFC 2537 RSA/MD5 KEYs and SIGs in the DNS March 1999 Full Copyright Statement Copyright (C) The Internet Society (1999). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Eastlake Standards Track [Page 6]