You are here: irt.org | RFCs | RFC4243 [ previous next ]
Network Working Group M. Stapp
Request for Comments: 4243 R. Johnson
Category: Standards Track T. Palaniappan
Cisco Systems, Inc.
December 2005
Vendor-Specific Information Suboption for the
Dynamic Host Configuration Protocol (DHCP) Relay Agent Option
Status of This Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2005).
Abstract
This memo defines a new Vendor-Specific Information suboption for the
Dynamic Host Configuration Protocol's (DHCP) relay agent information
option. The suboption allows a DHCP relay agent to include vendor-
specific information in the DHCP messages it forwards, as configured
by its administrator.
Table of Contents
1. Introduction ....................................................2
2. Requirements Terminology ........................................2
3. The Vendor-Specific Suboption ...................................2
4. Relay Agent Behavior ............................................4
5. DHCP Server Behavior ............................................4
6. Security Considerations .........................................4
7. IANA Considerations .............................................5
8. Acknowledgements ................................................5
Normative References ...............................................5
Informative References .............................................5
Stapp, et al. Standards Track [Page 1]
RFC 4243 Vendor-Specific Relay Suboption December 2005 1. Introduction DHCP (RFC 2131 [2]) provides IP addresses and configuration information for IPv4 clients. It includes a relay agent capability, in which processes within the network infrastructure receive broadcast messages from clients and forward them to DHCP servers as unicast messages. In network environments like DOCSIS data-over- cable and xDSL, for example, it has proven useful for the relay agent to add information to the DHCP message before forwarding it, using the relay agent information option (RFC 3046 [3]). Servers that recognize the relay agent option echo it back in their replies, and some of the information that relays add may be used to help an edge device efficiently return replies to clients. The information that relays supply can also be used in the server's decision making about the addresses and configuration parameters that the client should receive. In many environments, it's desirable to associate some vendor- or provider-specific information with the clients' DHCP messages. This is often done using the relay agent information option. RFC 3046 defines Remote-ID and Circuit-ID sub-options that are used to carry such information. The values of those suboptions, however, are usually based on some network resource, such as an IP address of a network access device, an ATM Virtual Circuit identifier, or a DOCSIS cable-modem identifier. As a result, the values carried in these suboptions are dependent on the physical network configuration. The Vendor-Specific suboption allows administrators to associate other useful data with relayed DHCP messages. 2. Requirements Terminology The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [1]. 3. The Vendor-Specific Suboption This memo defines a new DHCP relay agent option suboption that carries vendor-defined data. The suboption takes a form similar to the Vendor-Identifying, Vendor-Specific Option [7]. Stapp, et al. Standards Track [Page 2]
RFC 4243 Vendor-Specific Relay Suboption December 2005 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Code | Length | Enterprise Number1 | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | | DataLen1 | | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ + \ Suboption Data1 \ +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Enterprise Number2 | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | DataLen2 | Suboption Data2 | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ \ \ . . . . +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ The Code for the suboption is 9. The one-byte Length field is the length of the data carried in the suboption, in bytes. The length includes the length of the first Enterprise Number; the minimum length is 4 bytes. "Enterprise NumberN" is a vendor's Enterprise Number as registered with IANA [4]. It is a four-byte integer value in network byte- order. DataLenN is the length of the data associated with the Enterprise Number. The Suboption Data is an opaque sequence of bytes. The Vendor-Specific suboption includes at least one Enterprise Number and carries opaque data defined by the organization identified by the Enterprise Number. A relay may include data associated with more than one vendor's Enterprise Number within a single instance of the Suboption. Of course, the Vendor-Specific data are vendor-specific. This specification does not establish any requirements on the data in the suboption. Vendors who make use of this suboption are encouraged to document their usage in order to make interoperability possible. Stapp, et al. Standards Track [Page 3]
RFC 4243 Vendor-Specific Relay Suboption December 2005 4. Relay Agent Behavior DHCP relay agents MAY be configured to include Vendor-Specific suboptions if they include a relay agent information option in relayed DHCP messages. The suboptions' types and data are assigned and configured through mechanisms that are outside the scope of this memo. Relay implementors are encouraged to offer their administrators a means of configuring what data can be included in this suboption, and to document what they are capable of. 5. DHCP Server Behavior This suboption provides additional information to the DHCP server. The DHCP server, if it is configured to support this suboption, may use this information, in addition to other relay agent option data and other options included in the DHCP client messages, in order to assign an IP address and/or other configuration parameters to the client. There is no special additional processing for this suboption. 6. Security Considerations Message authentication in DHCP for intradomain use, where the out- of-band exchange of a shared secret is feasible, is defined in RFC 3118 [5]. Potential exposures to attack are discussed in section 7 of the DHCP protocol specification in RFC 2131 [2]. The DHCP relay agent option depends on a trusted relationship between the DHCP relay agent and the server, as described in section 5 of RFC 3046. Fraudulent relay agent option data could potentially lead to theft-of-service or exhaustion of limited resources (like IP addresses) by unauthorized clients. A host that tampered with relay agent data associated with another host's DHCP messages could deny service to that host, or interfere with its operation by leading the DHCP server to assign it inappropriate configuration parameters. While the introduction of fraudulent relay agent options can be prevented by a perimeter defense that blocks these options unless the relay agent is trusted, a deeper defense using authentication for relay agent options via the Authentication Suboption [6] SHOULD be deployed as well. There are several data in a DHCP message that convey information that may identify an individual host on the network. These include the chaddr, the client-id option, and the hostname and client-fqdn options. Depending on the type of data included, the Vendor-Specific suboption may also convey information that identifies a specific host or a specific user on the network. In practice, this information isn't exposed outside the internal service-provider network, where DHCP messages are usually confined. Administrators who configure data that will be used in DHCP Vendor-Specific suboptions should be careful to use data that are appropriate for the types of networks Stapp, et al. Standards Track [Page 4]
RFC 4243 Vendor-Specific Relay Suboption December 2005 they administer. If DHCP messages travel outside the service- provider's own network, or if the suboption values may become visible to other users, it may raise privacy concerns for the access provider or service provider. 7. IANA Considerations The IANA has assigned the suboption number 9 for the Vendor-Specific Information Suboption from the DHCP Relay Agent Information Option [3] suboption number space. 8. Acknowledgements The authors are grateful to Andy Sudduth, Josh Littlefield, and Kim Kinnear for their review and comments. Normative References [1] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [2] Droms, R., "Dynamic Host Configuration Protocol", RFC 2131, March 1997. [3] Patrick, M., "DHCP Relay Agent Information Option", RFC 3046, January 2001. [4] IANA, "Private Enterprise Numbers (http://www.iana.org/ assignments/enterprise-numbers.html)". Informative References [5] Droms, R. and W. Arbaugh, "Authentication for DHCP Messages", RFC 3118, June 2001. [6] Stapp, M. and T. Lemon, "The Authentication Suboption for the Dynamic Host Configuration Protocol (DHCP) Relay Agent Option", RFC 4030, March 2005. [7] Littlefield, J., "Vendor-Identifying Vendor Options for Dynamic Host Configuration Protocol version 4 (DHCPv4)", RFC 3925, October 2004. Stapp, et al. Standards Track [Page 5]
RFC 4243 Vendor-Specific Relay Suboption December 2005 Authors' Addresses Mark Stapp Cisco Systems, Inc. 1414 Massachusetts Ave. Boxborough, MA 01719 USA Phone: 978.936.0000 EMail: mjs@cisco.com Richard Johnson Cisco Systems, Inc. 170 W. Tasman Dr. San Jose, CA 95134 USA Phone: 408.526.4000 EMail: raj@cisco.com Theyn Palaniappan Cisco Systems, Inc. 170 W. Tasman Dr. San Jose, CA 95134 USA Phone: 408.526.4000 EMail: athenmoz@cisco.com Stapp, et al. Standards Track [Page 6]
RFC 4243 Vendor-Specific Relay Suboption December 2005 Full Copyright Statement Copyright (C) The Internet Society (2005). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf- ipr@ietf.org. Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society. Stapp, et al. Standards Track [Page 7]